Description
Overview
Argo Output Spline Shaft Circlip retains components on the output spline shaft in an Argo V Drive gearbox. Fit it into the shaft groove to stop axial movement during operation. Because the clip sets end-float control, replace it if you see wear or loss of tension.
Features
- Circlip style retainer for a grooved output spline shaft.
- Supports secure component location at the output end of the gearbox.
- Compact part that suits routine service, rebuild, and teardown work.
- Helps prevent parts walking along the shaft under thrust load.
Also, a fresh circlip can reduce repeat leaks or noise that come from shaft movement.
Specifications and Materials: Argo Output Spline Shaft Circlip
| Item | Details |
|---|---|
| Product type | Circlip / retaining ring |
| Intended location | Output spline shaft groove |
| Part Number (ID) | AM2400 |
For general retaining ring types, groove concepts, and installation basics, use the Rotor Clip Ultimate Retaining Ring Guide as a practical reference.
However, confirm groove size and shaft diameter on your gearbox before you order.
Compatibility and Fitment: Argo Output Spline Shaft Circlip
This Argo Output Spline Shaft Circlip suits Argo V Drive gearboxes that use a circlip on the output spline shaft. First, confirm the groove position and ring type on the shaft. Next, check the groove for burrs and clean it fully. Then fit the circlip with the correct pliers and seat it into the groove.
After you install it, rotate the shaft by hand and check for free movement. If the ring does not seat evenly, remove it and inspect the groove again. Therefore, you avoid distortion that can reduce retention strength.
Compliance and Safety
Disconnect the battery and isolate the driveline before you work near rotating parts. Use eye protection, because circlips can spring free during removal. Also, follow your workshop procedure for torque checks and final inspection.
Marine Applications
V-drive gearboxes often see thrust loads from propeller drive and shifting events. As a result, retaining hardware at the output end plays a key role in reliability. Use this circlip during rebuilds, output shaft servicing, or when you replace worn bearings and spacers.
Why Choose Argomarine
Argomarine supports Argo V Drive gearbox servicing with stocked parts and clear product identification. So you can order by AM2400 and keep your job moving. If you also need related hardware, match the circlip to the shaft and groove during assembly.
Shop related Argo V Drive gearbox parts in our Gear Box Parts for Argo V Drive gearboxes online.
